6 Features of Dashboard Design for Buses

May 23, 2025

Leave a message

The dashboard body of a bus is an important functional and decorative part of a bus, which is a thin-walled and large volume part with a lot of holes and holes for installing instruments.

 

info-888-453

 

The following is an introduction to the six characteristics of the bus dashboard design.

1.Design Simplification
Competitive pressures to reduce costs and increase productivity have prompted vehicle manufacturers to focus their attention on the dashboard. This is due to the complexity of the dashboard and the size of the decision. Rapid assembly by combining parts can significantly reduce costs. The question is how best to simplify the design while maintaining or improving the performance of the dashboard.

 

2. Fewer physical prototypes
The prototype phase of bus design is the longest and most expensive phase in the vehicle development cycle. Under pressure to accelerate the development of new models, OEMs are looking for a way to retain original performance while reducing the time spent in the prototype phase. To achieve this, OEMs are adopting tools such as math and computer-aided manufacturing engineering CAE, which use finite element models to replace the entire physical experimentation of making a part.

 

3. Mass Reduction
Under the pressure to increase fuel economy, the mileage that can be traveled by buses, and the need for stricter compliance with CAF standards, OEMs should reduce the quality of parts throughout the entire production line.

 

4. Greater safety
Safety issues prompted the use of more ductile materials, collision, the material is required to be able to better absorb energy, but also the dashboard material due to brittle and caused by the problem of cracks. Therefore, the dashboard parts are required to have a higher modulus in order to provide torsional strength in the side impact and to achieve a high NVH target.

 

5. Noise, vibration, and ride smoothness NVH reduction
Users require vehicle manufacturers to make noise reduction a major aspect of overall quality and value.

 

6. Aesthetic effect
Improvement of thermoplastic engineering plastics made of bus dashboard parts in the plane of the form of better, in improving aesthetics can provide more choices.

 

7. Larger thermoplastic
At present, the bus in the sharp front corners of the use of a large number of glass, these enhanced glass increases the absorption of solar energy, can make the car's internal temperature rises sharply, according to the dashboard whether or not to fill the dashboard, the dashboard does not all the areas and the other areas of the fuse belt requires the use of heat deformation strength range of 100 ~ 120 degrees of the material, and the dashboard of the lower part of the requirements of the slightly smaller, the heat deformation temperature in the 85 ~ 90 degree Range.